[Alpha 10] AI check order change

[GFX47]

As you may already know, the way AIs are checked is changing in Alpha 10.

Before Alpha 10, it was checked from left to right using the nodes horizontal position.

Alpha10_AI_check_before.jpg (109.27 KiB) Viewed 3315 times

From Alpha 10, it will be checked anticlockwise using the parent link angle.

Alpha10_AI_check_after.jpg (108.57 KiB) Viewed 3315 times

Be sure to check and eventually fix your AIs when updating to Alpha 10!

[LuBeNo]

What if 2 nodes share the exact same angle, but one connection is longer? (the snap to grid encourages this)
It should fall back to left to right then!?

2 nodes.png (1.99 KiB) Viewed 3310 times

What if 2 nodes share the exact same position. (is it possible - should it be possible?)

[GFX47]

It's currently not handled, resulting in an undetermined behavior (do it at your own risks!).
I'll handle it to fallback to the left to right node position in the next version.

[Kanishka]

It's currently not handled, resulting in an undetermined behavior (do it at your own risks!).
I'll handle it to fallback to the left to right node position in the next version.

Tested... The Node closer to parent is evaluated first.

[GFX47]

It actually depends on other factors that may make it look random.

[Miojo]

How about nodes above the parent ?

[GFX47]

The angle is computed between the vertical above the parent and the link, anticlockwise.

[Jeffrey Harpen]

Damn, I have to rearrange all my AIs...
On the other hand it's good opportunity to get rid of some garbage and make my AIs clean and tidy. (Finally!)

[mcompany]

http://nooooooooooooooo.com/

Fine, I'll see what I have to fix